T-800 Meat hang
STORRWALL T-800 Meat hang
The perfect partition for your Meat hang trailer
Our T-800 Meat hang partition is made to measure. The upper part of the partition that can be folded down is made according to the specifications of the pipe track
spacing and design.
Save up to 40% refrigerator fuel now with our robust, universally applicable T-800 Meat hang. With a K value of 0.4 K/m2W and its self-locking double seals, the STORRWALL T-800 Meat hang thermal partition wall not only saves fuel, but also the climate-damaging gas CO2.
The STORRWALL T-800 meat hang thermo partition is the lightweight among partition walls. If components wear
out at a later point in time, all components can be assembled and replaced in-house.
That saves time and your money.
We are happy to offer you assembly, repair and maintenance as a service.
(Please use our order form with the T-800 meat dimension sheet to download from the online
catalog.)
Meat hang Operating stick
To easily open/close the upper segment, it is equipped with an operation stick or pulls trap.
Sealing for suspension tracks
The openings at the upper segments of the partition wall are sealed around the suspension tracks by double sealing flaps provided with incisions which close perfectly.
Dimensions form
Use the StorrWall pipe track order form. It is very important to fill the form complete for the best result. You can download the form on this page.
Extra hygienic sealing
In order to prevent contamination in meat transport, the exposed top-edges of the bottom protection (U-profile) are provided with an extra watertight welded seal.
T-800 Spare parts and Extra options
Built-in fan kit „large“
For installation in all T-800 walls of 82 mm thick, complete with spiral cable and temperature sensor and ready for use. Available in 12 volts or 24 volts.
Capacity 1300 m3/h
Spiral cable with 2-pole plug
Is included as standard in the above fan kits. Also separately available as in length
6 m and 12 m with mounted 2-pole plug fitting in fan kit. Other side unfinished. Here a plug must be fitted, matching the socket in the
vehicle.
Foil colors
Standard colors ( in addition to blue) are grey, yellow and green. Are often available without extra costs. Other colors, texts, logos, fleet numbers etc. we can
provide and apply at extra cost!
Bottom-protection
Available as a version with 20 cm side height or as an extra floor protection with 33 cm side height. The 5 mm high, pre-drilled wear protection is attached under
the floor protection.
(Picture above with wear protection)
Return ventilation opening
Is standard installed in combination with fan kit to obtain return circulation from „warm“ side to „cold“ side of the partition wall. However, also separately available (without fan) to get yourself a certain inlet of cold air in the second compartment. Sealing flap is provided with velcro and to adjust the opening space. With long-term non-use, a 20x20cm spacer is also available to optimize insulation.
Stable Handgrip
Handgrip set (standard)
1 set consisting of 2 handles (front and rear) and 4 stainless steel mounting plates with accompanying mounting bolts for 82mm thick walls. (T-800)
„Extra“ handle
The same as standard, however provided with Velcro to create a loop to fix a load restraint bar or beam to the wall.
Cargo restraint equipment
A wide range of tested mechanical and textile products.
You can find load securing in our shop.
Repair kit
With self-adhesive PVC tarp and cleaning cloth size 20x30cm.
